Cool Neon Artist's Kit (KA)

This Kit Includes:

20 feet of Phat 3.2mm Aqua with connector soldered on
5 feet of the following colors with connector soldered on:
Standard 2.3mm- Lime, Blue, Yellow, Purple, Green, Pink & Red.

Plug & Play Fish Driver- This driver is ready to drive any two of the above lengths of wire, mix & match. To power off wall current you can purchase an AC Power Supply (sold separately).

Plug & Play Strobing Driver- Add 2 AA batteries and this sleek hand-held driver will power any of the 5’ wires above with strobe or steady on mode.

Plug & Play Pocket Pack Driver- Runs 2-20 feet of wire with on/off and blink mode, on 4 AAA’s

5 Channel Pocket Sequencer (#SQ5P)
Our most compact sequencer. Sequences in 8 patterns in fast or slow, and comes with our Plug & Play connector set, making this sequencer ideal for any of your projects. Powered by four AAA batteries, and equipped with an external power input port so you can use our AC adaptor. Note the maximum wire length for this units is about 5 feet per channel.

(Plug & Play means the driver is ready for any of the pieces of wire to be plugged right into it, Just add batteries and you’re glowing)

8 AA Battery Pack Holder- Same connector as a 9V, but now you’ve got 12V and a set up that is far more economical amp-hour per dollar

Color Changing Egg: a beautiful item from our LED Fantasia collection, this egg contains RGB LEDs that slowly morph through a wide spectrum of mesmerizing colors.

Pipsqueak driver with PC power input, on-off switch, and 2 Cool Neon plug and play outputs.

One technostrobe 4 foot unit.

Our Silver Sound Activated Driver -20ft to 50ft- pulses and fades to music- a super cool effect that no other driver that we carry has!

Techno Flash Funlight- 2 feet of our Standard (2.3mm) Cool Neon attached to an AAA driver with blink or steady on.

one 9-volt battery cap, three “Y” connectors, three wire side connectors, one driver side connector, copper foil tape and heat-shrink tubing (So you can try your hand at soldering).

5 feet of metal armature wire which may be used as a frame for your project.

And lastly:
6 Volt AC Power Supply (#AC6V)
This sleek 6 Volt AC Power Supply Will power your Pocket Pack Driver, and your 5 Channel Pocket Sequencer using wall current. No batteries required!