404 All Surface Floor Polish   Price: $6.50 All Surface Floor Cleaning Kit   Price: $23.99 Replacement Microfiber Pad for All Surface Floor Cleaning Kit   Price: $5.99 810 All Surface Floor Cleaner Spray   Price: $6.25 810 Concentrate   Price: $13.00

All Surface Floor Cleaning Kit   Price: $23.99 Price Per:     Each   Replacement Microfiber Pad for All Surface Floor Cleaning Kit   Price: $5.99 Price Per:     Each   404 All Surface Floor Polish   Price: $6.50 Price Per:     Each   810 All Surface Floor Cleaner Spray   Price: $6.25 Price Per:     Each   810 Concentrate   Price: $13.00 Price Per:     Each   922 Urethane Adhesive Remover   Price: $41.50 Price Per:

DIRECTIONS

Use as a urethane release agent:

Wipe each board with Sentinel 922 wipes prior to spreading urethane glues to ensure easy clean-up of urethane adhesives on finished wood floor. Be sure to thoroughly wash the newly installed floor with Sentinel 810 All-Surface Floor Cleaner once installation is complete. Floor will be extremely slipper with remover residue on wood surfaces.

Directions for use:

1. Unscrew container cover, remove and discard foam seal. From center of roll, pull up corner of towel, twist to a point and thread through hole in underside of cover. Replace cover tightly. Pull towel and tear at perforation.

2. Rub area of floor that has cured or wet adhesive using a towel.

3. If the adhesive has cured for more than 48 hours, lay a towel over the cured adhesive and let stand approximately 5 minutes. Wipe area clean with a fresh towel.

4. Wipe entire area cleaned with a cleanwater-dampened cloth.

Note: Be sure NOT to scrub the surface of the finished wood too aggressively as this will change the look of the finish. Do not allow excess remover to drip between floor boards. Close cap when not in use. Store in a clean, dry area.