MB
Accessories
Installation Instructions
Mercedes-Benz V60 adapter with
Bluetooth� wireless technology
V60 adapter
The Mercedes-Benz approved/
recommended Bluetooth� Phones can be
utilized inside Mercedes-Benz vehicles.

Validity

 Please contact your Mercedes-Benz Dealer
to validate if your vehicle is supported. The
vehicles need to have the Mercedes-Benz
mobile telephone kit installed and a
Mercedes-Benz-approved Bluetooth�
mobile telephone. Approved mobile
telephones are listed and can be purchased
on the Internet at www.wireless4mb.com or
call 1-800-266-7746 to speak to a wireless
activation specialist.

Parts included
  1. Mercedes-Benz V60 adapter with Bluetooth� wireless
    technology
warningWarning

It is not recommended to operate the mobile
telephone keypad while driving.
Inserting the Mercedes-Benz V60
adapter with Bluetooth�

Make sure that the starter switch is in
position 1, 2 or 3 (see the vehicle Operator's
Manual).

Inserting

Insert the Mercedes-Benz V60 adapter with
Bluetooth� (1) into the connector (2) to
engage it into the cradle (3).

Note

After the adapter is inserted, the LED
button (4) will flash slowly in order to signal
that it is ready for pairing. If this does not
occur, remove the Mercedes-Benz V60
adapter with Bluetooth� and re-insert it.
When the adapter is powered for the first
time, the LED (4) will flash fast, indicating
that it is in Discovery Mode.
Notes

The manufacturer reserves the right to
change technical details from those shown
in the illustrations contained in these
installation instructions.

These installation instructions also refer to
the vehicle Operator's Manual or the
COMAND Operator's Manual and mobile
telephone manual. Please refer to them for
reference.

Use of a mobile telephone other than a
Mercedes-Benz approved/recommended
model may result in improper performance
and cannot be supported or serviced by
Mercedes-Benz.
Pairing the mobile telephone with the
Mercedes-Benz V60 adapter with
Bluetooth�

Notes

Make sure that the starter switch is in
position 1, 2 or 3 (see the vehicle Operator's
Manual).

In order to be paired, the Mercedes-Benz
V60 adapter with Bluetooth� must be
connected into the cradle and the LED
button (4) must be flashing slowly.

If applicable the keypad lock feature should
be disabled on the mobile telephone.

Parring

  1. Press and hold the LED button (4) for approx. 3 seconds.
    The LED button (4) will begin to flash faster.
    The Mercedes-Benz V60 adapter with
    Bluetooth� is now in Discovery Mode and
    can be detected by a Bluetooth� mobile
    telephone.
  2. For information on pairing the mobile
    telephone, see the mobile telephone manual
    or visit www.wireless4mb.com for
    instructions. The Mercedes-Benz V60
    adapter with Bluetooth� will appear as "MB
    PhoneSystem" on the mobile telephone.
    Once the mobile telephone detects the
    Mercedes-Benz V60 adapter with
    Bluetooth�, the mobile telephone will
    prompt the user for a Pass-Key.
  3. Enter 62872 on the mobile telephone.
    Depending on the type of mobile telephone
    being used, it may be necessary to confirm a
    connection request (see the mobile
    telephone manual).
The LED button (4) will light up continuously,
the mobile telephone is now paired and has
stored its information in the Mercedes-Benz
V60 adapter with Bluetooth�.
The connection between the mobile
telephone and the Mercedes-Benz V60
adapter with Bluetooth� is established. The
connection is re-established automatically
each time the mobile telephone enters into
the Mercedes-Benz V60 adapter with
Bluetooth� range (approx. 30 ft), as long as
the mobile telephone is switched on, the
Mercedes-Benz V60 adapter with
Bluetooth� is enabled on the mobile
telephone, and the starter switch is in
position 1, 2 or 3 (see the vehicle Operator's
Manual).

Depending on the type of mobile telephone
being used, a message may appear in the
mobile telephone's display (see the mobile
telephone manual). The m obile telephone
will now change to hands-free mode. It is
possible to send and receive calls via the
hands-free system (see the vehicle
Operator's Manual or the COMAND
Operator's Manual.)

The Signal Strength indicator shows the
status of Mercedes-Benz V60 adapter. This
bar display represents the following:


    Graph1

  • 1 bar - the Bluetooth� connection is active.

    • Graph2

  • 2 or 3 bars -there is an error in the
    Bluetooth� connection.
  • If the mobile telephone is connected
    via Bluetooth� to the Mercedes-Benz
    V60 adapter with Bluetooth�, the
    telephone home screen will be shown.
  • "No service" will be displayed, if
    there is no access to the network.
Notes

If the pairing process is unsuccessful,
remove the Mercedes-Benz V60 adapter
with Bluetooth� from the cradle (see
page 11). Re-insert the Mercedes-Benz V60
adapter with Bluetooth� and pair it with the
mobile telephone (follow the pairing
procedure found on page 4).
A maximum of 2 mobile telephones can be
paired with the Mercedes-Benz V60 adapter
with Bluetooth�. Only one mobile telephone
is connected to the Mercedes-Benz V60
adapter with Bluetooth� at a time. If a third
mobile telephone is going to be paired with
the Mercedes-Benz V60 adapter with
Bluetooth�, then the information from the
first mobile telephone paired will be deleted
from the Mercedes-Benz V60 adapter with
Bluetooth�.

The telephone book from the mobile
telephone is automatically downloaded after
the connection, as long as this feature is
supported by the mobile telephone. For
more information, go to
www.wireless4mb.com on the Internet or
any Mercedes-Benz Center. Downloading
the telephone book can take several
minutes.

The telephone book size will vary between
vehicles.

Notes

Once the telephone book has been
downloaded any changes made to the
mobile telephone's telephone book will not
be updated in the vehicle automatically. In
order to update the telephone book press
the LED button (4) briefly (see page 4).

When using Bluetooth� the mobile
telephone uses more power. Since the
mobile telephone is not being charged the
battery should have a sufficient charge.

Neither SMS messages nor the mobile
telephone call-lists can be accessed via the
Operating System while the Bluetooth�
connection is established.

The signal strength of the mobile telephone
network is not displayed in the Instrument
cluster or radio COMAND unit.

Not every ring-tone of the mobile telephone
is supported by the COMAND or radio.

3-way-calling is not supported from the
Mercedes-Benz V60 adapter with
Bluetooth�. An audible peep will notify a
waiting call.

The Tele Aid System (emergency call
system) will continue to function as
designed as long as there is a valid service
contract.

Before making a Tele Aid Call, you should to
end a phone call.
   
Connecting the mobile telephone and the
Mercedes-Benz V60 adapter with
Bluetooth� manually

The mobile telephone can be used to
connect manually to the Mercedes-Benz V60
adapter with Bluetooth� (see mobile
telephone manual).

Notes

Before manual connection, the mobile
telephone must previously be paired with
the Mercedes-Benz V60 adapter with
Bluetooth� (see pairing procedure on
page 4).

When within the range (approx. 30 ft.) of the
Mercedes-Benz V60 adapter with
Bluetooth�, the connection between the
mobile telephone and the Mercedes-Benz
V60 adapter with Bluetooth� remains
active. Phone calls made using the mobile
telephone or COMAND or radio will use the
vehicle's hands-free system. For this reason,
the connection between the mobile
telephone and the Mercedes-Benz V60
adapter with Bluetooth� should be
disconnected manually if the mobile
telephone is taken out of the vehicle (see
page 10).

Connecting the mobile telephone and the
Mercedes-Benz V60 adapter with
Bluetooth� automatically

When the starter switch is in position 1, 2 or
3 (see the vehicle Operator's Manual), a
connection between the mobile telephone
and the Mercedes-Benz V60 adapter with
Bluetooth� will be established.

Disconnecting the Bluetooth�
connection automatically

The connection between the Mercedes-Benz
V60 adapter with Bluetooth� and the mobile
telephone is automatically disconnected
when the mobile telephone travels outside
of the range (approx. 30 ft) of the
Mercedes-Benz V60 adapter with
Bluetooth�.

Disconnecting the Bluetooth�
connection manually

The connection between the mobile
telephone and the Mercedes-Benz V60
adapter with Bluetooth� can disconnected
manually from the mobile telephone (see the
mobile telephone manual).


Errors

If the LED button (4) flashes very rapidly
make sure the LED button (4) is not stuck in
the Mercedes-Benz V60 adapter with
Bluetooth�.

If the LED button (4) continues flashing very
rapidly or if the connection between the
mobile telephone and the Mercedes-Benz
V60 adapter with Bluetooth� is
malfunctioning, then disconnect the
connection manually (see page 10) and
reestablish the connection manually (see
page 10). If this does not correct the
problem, please consult a Mercedes-Benz
Center or call 1-800-266-7746 to speak to a
wireless activation specialist..

Removing the Mercedes-Benz V60
adapter with Bluetooth�

Remove

Press the release latch (5) and remove the
Mercedes-Benz V60 adapter with
Bluetooth� (1) from the cradle (3).

Note

The Mercedes-Benz V60 adapter with
Bluetooth� is designed for permanent use in
the vehicle and should only be removed
during troubleshooting.

Appendix

LED status adapter status
lit continuously Mobile telephone
connected (see page 5)
slow flashing No paired mobile
telephone detected (see page 3)
fast flashing Discover Mode
(see page 4)
very rapidly flashing Stuck LED button or fail
state (see page 11)


Note

This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
  • This device may not cause harmful
    interference.
  • This device must accept any
    interference received, including
    interference that may cause
    undesired operation.
Limitations

Cars with Audio 30 and COMAND (only
M-Class vehicles, W 164):
After a Tele Aid Call you need iniate once a
call from the handset or wait for an incoming
call.

� 2005, Mercedes-Benz Accessories GmbH
Not to be reprinted, translated or otherwise
reproduced, either wholly or in part.
Mercedes-Benz Accessories GmbH,
Stuttgart � A DaimlerChrysler AG Company
12/05